BysonBox Guide

BysonBox Setup Procedures

To properly set up your BysonBox you will need to follow the subsequent steps (This applies to first time set and if they box is ever unplugged you will need to follow the same procedure).

Step 1

Plug in the network cable using an RJ45 cable connected to your main network switch

Step 2

Plug in the power cable (Make sure to plug in after the RJ45 cable)

Step 3

Push the Power Button and let the BysonBox connect to the webpage this can take a couple of minutes. On average, we suggest waiting 15 minutes. Once, the BysonBox is connected you will be able to run internal and external scans.

** If you have any issues during this process, please send an email to [email protected]